| Senior Electrical Engineer - Electronic Product Development Support - Santa Clara, CA (On-site) at Santa Clara, California, USA |
| Email: [email protected] |
| From: Amy Jones, Blackapple Solutions LLC [email protected] Reply to: [email protected] Title: Senior Electrical Engineer - Electronic Product Development Support Location: Santa Clara, CA (On-site) Required Skills: (Medical domain is a must) Job Profile: The primary job will be to support customer for their Electronic Product Engineering Activities and act as an Onsite-offshore co-Ordinator. The candidate shall also be self-driven to learn and adapt to new technologies & methodologies as the industry needs. Domain Specific Skills o Experience in Medical Instrumentation & Laboratory Product Design & Development. Preferred qualification Bachelor of Electrical / Electrical & Electronics Engineering/Electronics and Instrumentation/Communications Engineering Years of Experience [ Relevant] : 10 to 15 Years Roles & Responsibilities Design & Development of embedded electronics devices and assemblies. Collaborating with firmware, mechanical, testing and production teams. Resolving EMC/EMI issues and ensure timely release of product. Analyze the System Level Requirements and create an Architecture Design. Root cause analysis of Field return devices. Analyze Reliability issues and implement design changes and perform board level testing. Board and system level Verification and Validation. Review the Technical artifacts generated by customer as well as offshore team. Pre compliance testing (EMC/EMI). Offshore co-ordination and Customer Engagement. Design Experience Required Complete Hardware design lifecycle including compliance testing and certification. Design and development of Analog, Digital circuits. Discrete circuits building with OPAMP, Mosfet, Transistors, ADC, DAC, Isolators, High side load switches. Microcontrollers, FPGA, DDR4, DDR3 SDRAM, SRAM, Flash Memory and EEPROM. High-speed designs USB, I2C, SPI, UART, RS232, RS422/485 communication interfaces. MTBF, DFMEA. Good knowledge of manufacturing / prototyping process. Schematic Design and PCB Layout review. Technical Documentation and V&V report generation. Knowledge in Regulatory Standards, EMI/EMC/ENV/UL/Reliability standards. Knowledge in Medical device Product Standards- IEC60601-1, Medical device Product development lifecycle process & documentation. Proficient in safely using most of the lab equipment used for electronic product development: Oscilloscopes, Logic analyzer, electronic loads, signal generators etc. E-CAD Tools OrCAD Capture ( Circuit design Schematics) Siemens (Mentor Graphics) PADS Layout Keywords: California Colorado |
| [email protected] View all |
| Fri Feb 17 14:22:00 UTC 2023 |